|
Toshiba
TEC Ribbon Saving Module
B-4905-R-QM
Warning
|
Disconnect the power cord before
installing the Ribbon Saving Module |
1. PACKING LIST
All the following parts are supplied with the kits. Make sure
you have all items shown below.
Description
|
Q'ty/Unit
|
Ribbon Saving Module
|
1
|
2. INSTALLATION PROCEDURES
| STEP 1. |
Turn the head lever counterclockwise to release the ribbon shaft holder
plate. |
| STEP 2. |
Remove the ribbon stopper from the ribbon shaft on which the ribbon is
wound. Before removing the ribbon stopper, check its attaching direction for later
installation. Remove the ribbon stopper from the ribbon shaft on which the ribbon is
wound. |
| STEP 3. |
Remove the two SM-4 x 88 screws to detach the solenoid attaching plate. |
| STEP 4. |
Pass the solenoid harness, of the ribbon saving module, through the
opening from the print block side and connect to CN14 (B472) or CN12 (B572) on the CPU PC
board. Fix the harness with the clamp. |
| STEP 5. |
Install the ribbon saving module on the print block. STEP 6. Assemble
the solenoid unit so that the head up link engages the spring pin. STEP 7. Secure the
ribbon saving module with the SM-4 x 88 screws removed in STEP 3. |
| STEP 8. |
Set the DIP SW 1-1 to ON. |
NOTE: Make sure to remove any dust that appears
during removal or installation because it may affect the print quality
CAUTION:
Take care to orient the screws so that they are vertically
aligned with the ribbon saving module. |
|
